What people keep running into with flashing
Complaints tagged flashing, each raised by more than one person. One-off posts are not included.
9 recurring problems · 137 people · 5 forums we read
Raised more than once
Most people first.
- 65How to tell if roof flashing is installed wrongPoorly installed roof flashing relies heavily on caulk rather than proper metal integration, leaving homeowners with leaks and visually unacceptable work. Without clear industry standards to reference, it becomes difficult to dispute substandard craftsmanship and demand corrections from a roofing contractor.
- 29How to temporarily waterproof a damaged roof until replacementFinding short-term waterproofing methods prevents interior mold growth and further water damage while waiting months for a full roof replacement. Improvised fixes like adding new concrete layers often fail to stop leaks completely, making reliable temporary patches essential without risking worse damage.
- 13Water leaking from roof corners and sidewallsImproper shingle overlapping and flashing near corners cause water to wick sideways or get trapped under the upper layers instead of flowing downward. This leads to chronic water intrusion and rotted roof decking during heavy rain.
- 12How to fix a leaking skylight after rainWater leaks around a skylight during a windy rainstorm are typically caused by a compromised seal or flashing at the top of the frame. Inspecting the roof helps identify whether the seal has failed or if additional flashing like a cricket is needed to divert water away from the opening.
- 7How to fix loose metal roof trim that won't stay inWhen wind bends metal roof edge trim away, simply pushing it back into the existing holes fails to secure it in place. This leaves an exposed gap that risks water running into the structure between the flashing and the wall.
- 4Can I install siding, soffit, and fascia before roof shingles?Installing siding and trim before shingles leaves the critical roof-to-wall flashing exposed and vulnerable to being redone. Doing the roof first ensures proper water-shedding integration where the materials meet.
- 4How to shingle around roof bends and height differences?Shingling around perpendicular roof joints and awkward bends is complicated by a two- to four-inch height difference between old and new roof sections. This leaves builders guessing whether bending or stapling shingles around sharp angles is correct and struggling to create a clean, properly sealed transition.
- 3How do I know if new chimney flashing is installed right?Homeowners replacing animal-damaged flashing often cannot tell whether a gap underneath is intentional or a spot where water will get in, and what else around the chimney—like a cap or cricket—needs attention. Because what sits beneath a piece can matter and advice conflicts, people hesitate to sign off or push back with contractors before making final payment.
- 2Do I need to reseal loose sealant around a stove pipe?Loose sealant around a stove pipe leaves a gap where water can enter, even when no water penetration is visible from inside yet. People want to keep water out on a metal roof or shop woodstove without knowing if resealing is needed right away or which product to use on both the metal roof and stove pipe.
Comes up alongside
Topics that keep appearing on the same problems — not topics with similar names.