What people keep running into with corrosion
Complaints tagged corrosion, each raised by more than one person. One-off posts are not included.
11 recurring problems · 102 people · 11 forums we read
Raised more than once
Most people first.
- 30Water heater going hot and cold with weird refill noisesOld water heaters can experience erratic temperature swings, long periods of running cold after heavy use, and strange refilling cycles. These sudden failures leave you without reliable hot water and make standard maintenance risky due to severe internal calcification, forcing homeowners to question whether to repair or replace the failing unit.
- 18Old water shut off valve won't turn offInternal mineral buildup and aging components cause old valves to fail completely, meaning turning the handle has no effect on the water flow. This forces homeowners to shut off the main water supply instead of being able to isolate specific fixtures like a washer or dryer.
- 14Car still has electrical problems and high voltage after replacing partsPersistent vehicle electrical faults like high voltage spikes and limp mode often continue even after replacing major components like the alternator, battery, and ELD. This leaves drivers completely stuck after trying everything, unable to reliably diagnose the root cause of the ongoing system failure.
- 11Is my repair estimate a rip-off?Technicians often give massive estimates, like 18 hours of labor for a gasket or $1,000 to replace a corroded cover plate, because dealing with severe corrosion carries a high risk of the repair failing. This worst-case pricing leaves owners of perfectly functioning equipment unable to determine if the expensive work is actually necessary or just an inflated quote.
- 5Exterior metal utility pipe rusting after one yearSurface oxidation on newly installed outdoor utility lines is usually a minor cosmetic issue rather than a structural hazard, provided the metal wall remains thick and intact. However, standard rust removers like CLR often fail on heavy exterior corrosion, leaving homeowners stuck trying to find stronger removal and prevention methods.
- 5What replacement material should I use for a corroded pipe nipple?Corroded galvanized pipe sections and completely seized threaded flanges connected to copper or brass elbows leave zero room to work in tight wall spaces. This makes it difficult to remove the damaged parts and determine the proper replacement material to stop leaks.
- 5Is severe brake rotor and caliper rust safe to drive on?Heavy corrosion and pitting on brake rotors and calipers can occur from winter road salt and outdoor parking, especially on certain vehicle models. While surface rust is common, severe rust gaps where the disc meets or caliper binding can indicate a dangerous issue that requires immediate inspection or replacement to ensure safety.
- 4How to fix a corroded speaker wire connector without drilling out rivetsCorrosion can cause speaker wires to break right off the connector, but drilling out the factory rivets to replace the terminal is unnecessary. Instead, you can buy a replacement pigtail harness and splice it directly into the existing wires to restore the connection.
- 4Do I need a plumber for rusted water heater connections?Brown rust on connecting nipples slowly worsens over the years until water pools from the inlet and outlet and runs over the sides. Because people cannot tell if they can just replace the badly rusted parts or if the entire heater is ruined, they are left unsure how to fix it. If the connections are pooling water and you have to ask, you need to call a plumber.
- 4How to flare stainless steel brake lines in placeHard stainless steel brake lines frequently crack or slide out of the tool when attempting a bubble flare. Because the tool must be clamped in a vise and cranked down extremely tight, successfully flaring a new coupling directly on the vehicle is almost impossible.
- 2Why is mysterious rust appearing on my hardware?Unexplained rust, crusty buildup, or dark discoloration can suddenly appear on household fixtures or walls without an obvious cause. This leaves homeowners unable to identify whether the damage stems from chemical exposure, heat, or structural work like new exterior render, making it impossible to know how to stop it from corroding surrounding hardware.
Comes up alongside
Topics that keep appearing on the same problems — not topics with similar names.