Will epoxy fill in rough spots and grinding marks?
Epoxy does not completely fill in rough grinding spots or residual tool marks. These textures can stick out through the top of the finished coating, leaving an abrasive surface that feels like asphalt or coarse sandpaper. Because the floor constantly catches on microfiber washcloths, it becomes practically impossible to clean.
Core Friction Pattern
Analysis of 2 peer accounts across online developer and community forums reveals that “Will epoxy fill in rough spots and grinding marks?” repeatedly surfaces due to edge-case mismatches between standard defaults and real-world environments. Standard troubleshooting frequently falls short, compelling practitioners to develop custom workarounds.
+1 alternative community-tested workaround cataloged below.
What people tried
Every workaround mentioned in the threads below. We haven’t tested any of them — and nobody here is claiming they worked.
Found another way around this?
Share your steps and trade-offs so fellow engineers don't have to reinvent the wheel. No account required.
Will epoxy fill in rough spots and grinding marks?
- 1re-renting and running a large floor grinder over the smooth spotsDid this help you?
- 2relying on full broadcast flakes to hide surface imperfections and sinsDid this help you?
In their words
Unedited, grouped by where they were said, most upvoted first within each place, each linked to the thread it came from.
“Now im nervous that the epoxy won't fill these type of spots”source ↗
“Do I need to go back and rent the big grinder again or are these spots able to be filled with the epoxy?”source ↗
“im so nervous to vacuum and clean the floors just to apply the stuff to find out i fd up”source ↗
“It feels awful, like asphalt. It's not smooth at all, I cannot imagine trying to clean this.”source ↗
“The problem is that some of them are sticking out of the top of the epoxy. So if you run your hands over it you feel these little flexible pieces.”source ↗
“I dragged a small microfiber washcloth over it and it was catching so bad, like pulling it over the coarsest sandpaper.”source ↗
Where this came up
People with this problem also raised
Related community dilemmas clustered by discussion consensus
How to tell if floor marks are a manufacturing defect or installer error
Strange marks and black spots appearing on new flooring can stem from factory flaws or installation issues. Because these recurring blemishes resist hand polishing, homeowners struggle to identify the root cause before contacting their installer.
Why is my floor finish lifting and scratching so easily?
The surface is so fragile that simple actions like removing painter's tape or using a wheeled vacuum cause immediate lifting and scratching. On materials like luxury vinyl plank, the joints can even delaminate, leaving people unsure if the damage is caused by a bad product or a poor installation.
How to fix a gouged or cut floor
Cutting into or tearing up a floor while searching for a lost cable or moving an appliance leaves visible damage that threatens security deposits and home aesthetics. DIY repair methods allow renters and homeowners to restore the surface without professional intervention.
Why is my laminate floor bubbling at the seams?
Water exposure from incidents like flooding or spills from a dog water bowl causes laminate boards to develop hard, solid ridges along the seams. These raised edges have no give and can be felt when walking barefoot or seen when the light hits them just right, leaving people unsure of the best steps to fix them.
How to fix white spots on a shower floor finish
Harsh chemicals or rough mop buckets can strip or chemically react with shower floor finishes, leaving behind stubborn white marks or dull circles. Because renters risk losing their deposit over surface damage, they often panic about whether the material is permanently ruined or can be polished out.
How to fix dull worn spots on laminate flooring
High traffic areas on laminate wear down over time, causing high spots to lose their original finish, show dark marks, or develop scratches. While some attempt to mask them with extra stain, standard finishes won't bond to laminate's protective wear layer, which usually leaves replacement as the only permanent fix.